|
Water
Bath Canning Vs. Pressure Canning
When
choosing how to pickle or what pickle recipes you would like
to try, there are a number of things you want to keep in mind.
One of those things is which canning method you would like to
use. Home canning is a very simple process that can be done
in two ways: pressure canning, or water-bath canning. Pressure
canning is a process that requires a pressure canner, which
can be often times, be expensive. You may however be able to
find a cheap one with a little bit of hunting through garage
sales or flea markets. Water-bath canning, on the other hand,
can be done using only a couple of simple tools. We will assume
that you will be using a water-bath canning method. The following
article will explain this particular method.
Firstly,
of course you will need a water-bath canner. You must make sure
it is deep enough to hold enough water to submerge your canning
jars by at least 1 inch. You will also need your canning jars,
screw-on bands, and canning lids. It is the much-less-expensive,
tried-and-true way of canning. It is a way of preserving hundreds
of foods, including salsa, jam, jelly, pickled fruits and vegetables,
as well as relish for hundreds of years. It is a great canning
method for beginners, or avid canners.
A
water-bath canner is basically a large pot with a rack that will
hold up to seven mason quart jars or up to sixteen pint jars.
By using a large stock pot and being creative with wire, one could
improvise a rack to create their own water bath canner. As long
as the jars avoid direct heat from the burner and are completely
submersed in the water, a number of crafty setups could be used.
If you would like to save the trouble of rigging your own, they
can be readily purchased at many locations or online.
The
way a water-bath canner functions is that it increases the temperature
of your canning jar to a temperature hot enough to kill yeast,
bacteria, and molds that are found in food. The heat also creates
air bubbles that push the air inside the jar out as the contents
inside the jar heat and expand. When the jar cools down to room
temperature, the air pressure creates a seal that prevents air
and other organisms from entering the jar, preventing the food
from spoiling, thus the reason for canning’s existence.
It
is essential that the jars are free of nicks or cracks and that
the rim is flat. They should also be newly washed, either by hand
or dishwasher, so they are sterile and free of any micro-organisms.
The process begins by filling the canning jar with the desired
ingredients. Make sure to wipe the rim clean with a laundered
towel so as to create an ideal seal. Place the lid on the rim,
making sure to center it so that the rubber is on the entire rim
and then screw on the band. The band does not need to be screwed
on tightly; over-tightened bands do not allow the gasses to escape
the jars. Then you will place the jars into the water-bath on
the rack. Make sure the water is covering all of the jars by at
least one inch and then bring the water to a boil. When finished,
turn off heat and let sit for a full five minutes before removing
jars from the canner. Be sure to let the canning jars cool, so
as not to burn yourself.
As
the canning jars cool off, the tops should pop closed as they
seal, meaning that; after sealing the tops will not depress by
pressing down on with your finger. If the jars are not sealed,
the center of the lid will pop up and down when pressed. Either
throw these jars away or eat the contents within a week. If the
lids did not seal, do not use them again as they will not seal
if used again.
Once
the jars are cooled they may be stored. It is best if they are
stored in a cool dark place like a basement or pantry. Contents
will be ready to eat according to the recipe. Make sure that before
eating, the contents are inspected for signs of spoilage: mold,
gas, cloudiness, odors, or drainage. If spoilage has occurred,
do not eat the contents of the can as it may cause serious sickness.
Here
is a simple pickling recipe for you to try out!
Delicious
Pickles:
Wash
cucumbers, pack into sterilized canning jars.
Solution
(sufficient for 3 gallons of pickles in glass jars):
1
gallon vinegar
1
cup salt
½
pound (16 tablespoons) dry mustard, make sure to fully mix the
dry mustard in with vinegar so that there are no clumps. A good
way to do this is to take a little vinegar and make a paste type
of substance with the dry mustard, then mix this into the vinegar.
Pour
mixture over cucumbers in your sterilized jars and seal at once
(Using the method of your choice.). Store pickles without removing
screw bands.
I
hope that this helps you to choose your method of pickling, and
make sure to head on over to my homepage for many more pickling
tips and recipes. Also visit the forums to share info with other
picklers.
Learn
much more on how to pickle, pickle recipes, pickle tips, and everything
else having to do with pickling at http://www.howtopickle.com
Check out the free newsletter to receive our Free Pickling Recipe
of the month, and share your joy of pickling with others at our
pickling forum!
Comments
(0) | Email this article | Category: Food Storage
|
|